OWNER'S MANUAL
AND
INSTALLATION GUIDE
ACC-56
MODEL ACC-56
REMOTE-CONTROL
RF MODULATED
10-DISC CD CHANGER
PACKING LIST
MAIN UNIT
FM Modulator
Changer
Remote Control
ACC-56
INSTALLATION PARTS
Bracket (L)
Screw(C)
Bracket (R)
Hexagonal bolt with washer
(M5 x 10)
5 Meter Din Cable
Phillips Head Self-Tapping
Screw
(M3x12)
1 pc.
1 pc.
7 pcs.
1 pc.
2 pcs.
Seals (A)
Seals (B)
Self-tapping screw
(M5 x 12)
1 pc.
1 pc.
4 pcs.
OTHER ACCESSORIES
Owner's Manual
and Installation Guide
CD Magazine (P/N ACC-56MAZ)
Index label sheet
1 pc.
1 pc.
1 pc.
3
REAR
BEFORE INSTALLING THE UNIT
Transport Lock Screws
The mechanism in the CD changer is "locked" into place during shipment by three
transport lock screws. Be sure to remove the screws prior to installation.
BOTTOM
FRONT
l Caution l
After removing the transport lock screws, place the supplied seals (A) over the screw
holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
TRANSPORT LOCK SCREWS
(2 RIGHT SIDE, 1 LEFT SIDE)
Installation and Wiring Precautions
To prevent a short-circuit,
lBe sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.
lConnect power wires last.
1
NOTE: If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not
disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these
conditions, use extra caution during installation not to cause a short circuit.
Do not install the unit in the following locations.
lLocations exposed to direct sunlight.
lWhere hot air is discharged from the car heater.
lIn areas subject to extreme temperatures.
2
Incorrectinstallationcancausethediscto"skip"whenplaying. BesureMounttheunitfirmlyinplace,usingthesupplied
brackets and screws.
3
4
lBe sure to use the supplied screws.
lBe careful not to snag any wires when tightening screws.
lDo not use any of the screws that are part of the brake or steering system, to install the unit.
lBe careful not to damage the car wiring.
lThis unit cannot be installed on its side, end, or upside down. Installation in such positions will cause malfunctioning
5
of the mechanism.
ADDITIONAL 10-DISC MAGAZINES
Additional CD Magazines are available as an accessory item (Part No. ACC-56MAZ). Visit the store where your ACC-56
was purchased or, contact Audiovox directly for pricing and shipping information (1-800-645-4994). All checks or money
orders are to be made payable to Audiovox Electronics Corp. NOTE: Never send Cash when ordering.
Audiovox Electronics Corp.
150 Marcus Blvd.
Hauppauge, N.Y. 11788
Attn: Parts Department
NOTE: New York residents, please include applicable sales tax.
4
WHERE TO INSTALL THE CHANGER
Afewofthemanymountingpossibilitiesareshownbelow.The followingprecautionsmustbeconsideredwhen selectingthe
mountinglocation.
InstallationCautionsandWarnings:
1. FuelTank-WARNING!Neverinstallaboveyourfueltankastheholesyoumustdrillmaypiercethetankorthefuellines.
Also check for other obstructions such as wires, etc.
2. ExcessiveHeat-Avoidareasexposedtodirectsunlight(ontopofrearpackageshelf)ornexttoyourcarheater’soutput
ducts.
3. Ease of Use - Make certain the changer is easily accessible for loading and unloading the CD magazine.
4. Distance - The data cable that joins the changer to the FM module is 15 feet long. Do not exceed this length.
5. If mounting to a plastic surface, do not use the self-tapping screws provided. Use the bolts and hex nuts provided for
a more secure installation.
IMPORTANT: Failure to properly secure the CD changer is the most common cause of all “skipping” and related
CD play problems. Changer must be mounted as explained on the following pages.
MOUNT ON SIDE OF
TRUNK MOUNTING (SEDANS)
MOUNT UNDER LIP OF TRUNK
TRUNK SIDEWALL
Thisisusuallytheeasiestlocationtouseasthereisamplespace
available.Checkthatyoudonotinterferewiththeremovalofyour
spare tire, etc. Observe caution on fuel tank stated above. The
onlynegativeaspectistheneedtoroutethewiringfromthetrunk
to your car dashboard.
MOUNT ON FLOOR OF TRUNK
(HORIZONTAL OR 45 DEGREES)
MOUNT ON
SIDEWALL OF
CARGOAREA
HATCHBACKS, WAGONS&VANS
A simple investigation of the areas shown will often provide
severalpossibilities.Observecautiononfueltankstatedabove
and make sure the unit is protected from cargo, passenger
entry and exit, etc.
MOUNT ON BACKWALL
OF HATCH AREA
UNDER PASSENGER’S FRONT
SEAT/BEHIND SEAT
MOUNT UNDER
SEAT
MOUNT ON BULKHEAD BEHIND
SEAT OF PICKUP TRUCKS
If sufficient space and easy access exist, the area under the
passenger's front seat is ideal, and will also allow easy wiring
access. However,youmayneedtotemporarilyremovetheseat
foreaseofinstallation.Theareabehindeitherthepassenger’sor
driver’s seat on pickup trucks is another ideal location.
5
|